Review on 🔧 Double Removal Puller by Manelord: Ultimate Repair Tool by Michael Hellewell

I bought this to repair several car door dents and a large dent. I also bought a slide hammer kit and extra glue sticks. As you can see from the photos the dent is about 2 inches but not too deep and it's gone now. Here are some tips I would like to share: 1. When applying glue, do it seated next to the machine, even a short walk from the workbench to the machine, 10 feet, the glue will dry and not stick.2. Apply LOTS of glue to cover the entire connector well and let it run out while pressing it against the car.3. Let the glue dry. At least 10 minutes, even if the instructions say 4-5, give it more time.4. I pulled out most of the dent on the first try, but there was a small dent. I used a smaller fork to take it out. Clean up was easy, most of the glue came off with the plastic scraper included in the kit. Removed the rest with naphtha solvent and a microfiber cloth. I am now impressed to remove the large dent in the fender where my daughter hit the garage wall. It's about 4 inches long and 1 inch deep. I can use the slider first and then edit the rest. I will post updates.