Review on 🖨️ Blu High-Quality Printing with Resolute Precision by Tony Wylie

This resin is the best. I played around with other much more expensive engineering and hard resins that might not be as strong and a lot more difficult to set up. I'm using this on a standard Mars Elegy and the Siraya recommended settings give perfect detail. . I print at home, the temperature is usually around 70°, but I check the temperature of the resin and it reaches the recommended temperature in around 30 minutes. If you're printing fine print, consider placing a heat lamp or something similar on it before you begin. The details are great. I made a badge with 3D Mario, everything was super visible even at 1/2 inch thickness. Very accurate and dimensionally accurate for functional parts. It holds the threaded inserts very well (I use a flanged insert) and hasn't pulled one out yet. Has a bit of flex when flimsy, used this resin for a 3" clip/mount and it stretched 1" with no problem (second part in my photos). There is definitely a very slight brittleness, I broke a part but it was too tight initially. I dropped and scored others with no problem. Easily sanded for finishing. After the part has cured and dried it will definitely become very hazy, but applying a clear coat to it will bring back the glassy surface. Good adhesion with standard spray paint (black part painted with Home Depot material). To be honest I don't think I will ever buy another resin again.