Review on HiLetgo Development Compatible Interface Arduino by Davaun Pritchard
Works great with USB Host Library 2.0
I bought 2 and they work fine. Sorry to everyone who got a defect. For Micro Pro 3.3V: 1. Disconnect the line between VBUS and 2k2 to get 5.0V2. Two jumper wires on VCC and RST, VBUS and RAW3. Place Micro Pro on USB host shield, align and connect: (top) INT, GND, (bottom) SS, MOSI, MISO, SCK, VCC, GND, RAWDone.
- Easy to read control panel
- Not bad
New products
Comments (0)
Top products in π₯οΈ. Single Board Computers
π Ultimate BBC Micro bit Sensor Starter Kit: Keyestudio 37-in-1 Box with Tutorial, Compatible with V1.5 & V2, Gift for Kids and Adults (Microbit Board Not Included)
11 Review
REXQualis Comprehensive Starter Kit with Arduino MEGA 2560 & Detailed Tutorial for Arduino IDE Compatibility
11 Review
55" TV LG OLED55C2RLA 2022 HDR, OLED, dark titanium
38 Review
π MCIGICM 2 Channel DC 5V Relay Module: Optocoupler Low Level Trigger Expansion Board for Arduino UNO R3, DSP, ARM, PIC, AVR, STM32, Raspberry Pi
11 Review
Another interesting products
π§ Premium Repair Replacement Screws & Tools for MacBook Pro Retina 15"/13" - Complete Bottom Case Set
10 Review
Comprehensive 500pcs Laptop Screw Kit Set for π© IBM HP Dell Lenovo Samsung Sony Toshiba Gateway Acer
12 Review
MacBook Retina 13-inch (A1425, A1502) and π© 15-inch (A1398) Bottom Case Screw Set with Pentalobe Screwdriver
11 Review
π₯οΈ Helifouner 450-Piece Computer Standoffs Spacer Screws Kit: Ideal for Hard Drive, Motherboard, Fan, Power Graphics & Computer Cases
10 Review