Review on Enhancing Dimensional Accuracy with Filament 3D Printing: Advanced Additive Manufacturing Solutions by Raymond Gray

The most important thing I have to say about this particular white PLA is that it highlights the strongest combinations of the 8 brands I've worked with so far. So make sure you turn on the ventilation and if you can avoid printing in any of your living spaces I would recommend this more than any other brand I've tried. I print with the FLSUN SR which prints very fast so you already have to increase the temp at the nozzle but with this particular filament I print at 225 to avoid problems which is right in the middle of their recommended temps and slightly higher others I've worked with, but I knew what was going on. Doesn't wind very well on the reel. I've gone about 1/3 of the way through the spool and while it hasn't really caught on yet, the line is full of little kinks from constantly crossing over. This is the first brand I've bought so casually, but I think I'll spend a buck or two more on brands that will pay more attention in the future. 2 let me down until I stumbled across it at 220-225, but with the window open and the door to this room closed, I was still fed up with the fumes walking down the hallway and a day after printing the entered room. that was bad. With other brands, although not recommended, I could sit next to the printer while it was running and not even notice the smell, so I usually don't notice it when printing.