Review on 🛷 Bradley Heavy Duty Rubber Snow Tube and River Tube: The Ultimate Sledding Float for All Seasons by Mark Bearden

Try 3 inflate yourself to about 5 feet. It wasn't good enough and the pool cover pump didn't work in the last 1 inch of rain. The water level is 2 cm below the tile. The lid did not flow to the side and sagged under the weight. Just added a fourth tube and pumped them all to a full 6ft. This makes them 15 inches thick instead of 13. That seems enough for better drainage. Pricey but it should negate the need for a pump. Clearance 6 feet from edge and between pipes. No need to tie pipes in place. Super strong rubber. This is the first year of using hard coatings. Previously, only mesh covers were used, which required a lot of cleaning every spring to get rid of algae. I took a few shots that will hopefully show the contours of the pipes. I had to add some sandbags around the steps. This will prevent the sheets from getting under the cover. Today it's raining again and the water is running off the ground. Must also support the weight of eventual snow loads.