Review on 🕶️ NinjaTek Midnight NinjaFlex 3D Printing Filament by Jay Matlock

I was very hopeful after reading that the extruder used on the Prusa with the direct feed tube worked best, and only without slight heat and feed rate adjustments. may be required. I've tried many suggestions from the Prusa user group and some from the vendor. No consistency other than an insane jam in the extruder. I'll keep trying as time permits and if I ever succeed I'll report back. I've been typing on my Prus for two years and a Tevo with a Capricorn tube for a few more years. Today, if I still had it, I wouldn't consider using it with any tube feeding system I've seen.