Review on SOKOL computer table KST-14, corner: left, WxDxH: 140x123.5x182.8 cm, color: sonoma oak/white by Micha Banasiewicz ᠌

Overall a good table. there is where to place two 27 "monitors, a computer, ups, an oscilloscope, and a bunch of other little things. During assembly, one low-quality superstructure shelf came across, but it was replaced without any problems. and even more, they sent the whole set of shelves. I made an additional shelf out of one of them. The additional surface is too low, it would be more convenient if it was level with the main table top, while being the same in width. then it would be possible to use the place as a multifunctional one. now when you use an additional surface, your back gets very tired. The 16mm table top is quite thin, because of this, even when you press the table, the monitors on the table tremble. a blank partition does not allow the use of sockets located on the wall. A support for the superstructure would be better. I had to cut holes for the outlets. For drawers, very mediocre fittings are used; after a year of use, the drawers began to warp. It would be better to use ball fittings. [added] not every EXPENSIVE case will become a niche for a company. I specially selected the case to fit in there, but there is not enough air for hot components. I had to make a cutout on the side, and also push the computer forward (I used the shelves kindly sent by the manufacturer as supports :)) (fractal design meshify 2 case). I also made a cutout for sockets. I plan to remove the wall altogether and replace it with a barbell. the bottom shelf (where the computer is) is quite flimsy. bends almost to the very bottom. 16 mm countertop under the weight of the superstructure also sags. it does not comply with GOST. ideally the countertop d. B. 35 mm, well, at least 22 mm.