
These are quality flaps but unlike the rear ones they use rivet nuts for the top two holes on each side and I've sanded down part of the top flange on each nut so they go all the way in due to the raised portion of the wing. Also, I found that the 23/64" hole was too big to get the rivet nut in properly and I used a small amount of JB Weld on each of them to hold them in place. Instead, I suggest using an 11/32 inch bit.

ORCISH 12V 13000-lb Load Capacity Electric Truck Winch Kit π with Synthetic Rope - Waterproof Off Road Winch for Jeep, Truck, SUV
35 Review

SuperJump Trampoline with SuperJump 8ft (244 cm) net and ladder
29 Review

Get Ultimate Towing Stability With CURT TruTrack Weight Distribution Hitch & Sway Control - Up To 10K Capacity, 2-Inch Shank & 2-5/16-Inch Ball - In Sleek Black Design
30 Review

4WD ORCISH Recovery Traction Boards Tracks Tire Ladder For Sand Snow Mud - Set Of 2 (2Nd Gen Bag + Mounting Pins, Black)
39 Review