Review on Crisp And Accurate Green Prints With HATCHBOX 3D PETG Filament - 1KG Spool, 1.75 Mm Diameter by Jerome Pernell

Out of the box, filament performed OK. After drying it properly (which you should do with EACH and EVERY spool of filament you purchase) this stuff prints like a dream. Dialed in temps and retract settings, and this stuff doesn’t string at all. I tried this as a substitute to esun’s PETG, and I will never go back. Esun product was stringy and poorly wound to the point where multiple prints failed because the filament was wound over itself. Glue stick helps adhesion if you’re using a glass build plate with this PETG. Layer adhesion is exceptional, to the point where it’s very difficult to remove supports (so it’s a good and bad thing). I wish this stuff had a higher temperature resistance, but it can’t be good at everything. You will not regret buying this if you take the time to dial your settings in. Great stuff for functional and dimensionally accurate prints.