There is a lot of unused space in this closet. I drilled four holes in the top panel to install the hard drive. When choosing between cutting a hole for the hard drive and removing the back panel, the easiest way was to remove the platter. But it would be nice if the top and back were prepared for that given the dimensions of the case. The connector of the fan cable is only a few cm shorter than it can be connected to the connector on the expansion board. So either you use the GPIO header or you don't use it at all. If you want to use GPIO, stick with the latter. I don't understand why one of the speed features is a touchscreen since there isn't one.
Vilros Raspberry Pi 4 4GB Complete Starter Kit - Black Fan-Cooled Aluminum Case for Heavy-Duty Performance
12 Review
π MCIGICM 2 Channel DC 5V Relay Module: Optocoupler Low Level Trigger Expansion Board for Arduino UNO R3, DSP, ARM, PIC, AVR, STM32, Raspberry Pi
11 Review
π Ultimate BBC Micro bit Sensor Starter Kit: Keyestudio 37-in-1 Box with Tutorial, Compatible with V1.5 & V2, Gift for Kids and Adults (Microbit Board Not Included)
11 Review
REXQualis Comprehensive Starter Kit with Arduino MEGA 2560 & Detailed Tutorial for Arduino IDE Compatibility
11 Review
36-Pack Black Rubber PC CPU/Case Fan Screws/Rivets Set for Computer
11 Review
Comprehensive 500pcs Laptop Screw Kit Set for π© IBM HP Dell Lenovo Samsung Sony Toshiba Gateway Acer
12 Review
uxcell 3.5" HDD Screw Black 200pcs for Computer PC Case - Flat Phillips Head - 6#-32 - Hard Drive Fasteners
10 Review
Glarks 660 Pieces Phillips Assortment Motherboard
10 Review