Review on 🖨️ BuMat Printer Filament 1.75 Black: Premium Quality Printing Material for All Your Projects by George Kapoor

My first print with this filament at 195C was very bad, the layers were brittle and had poor adhesion. Compared to another brand I've used before (I won't name them here), I had to crank this thread to 210C and set the flow rate to 103% to get good layer adhesion with adequate side hoop strength. Once I did that, the part printed fine. If you intend to purchase and use this grade, be aware that it may need to be extruded at a higher temperature than the PLA temperature range to achieve good print quality.