🖨️ BuMat Printer Filament 1.75 Black: Premium Quality Printing Material for All Your Projects Review

I've been using the spool for about 4 months now and it's decent line. Prints are good, has a translucent appearance. The problem is that this filament is sticky as it likes to stick to the nozzle itself. It's frustrating at first, I have to "help" the filament on the first print, it curls up around the nozzle, if you don't go in there and crush it you're in for a mess. I've used other threads and haven't had this problem. In general it works, but you have to get used to its bad behavior.

My first print with this filament at 195C was very bad, the layers were brittle and had poor adhesion. Compared to another brand I've used before (I won't name them here), I had to crank this thread to 210C and set the flow rate to 103% to get good layer adhesion with adequate side hoop strength. Once I did that, the part printed fine. If you intend to purchase and use this grade, be aware that it may need to be extruded at a higher temperature than the PLA temperature range to achieve good…

I ordered this product expecting it to be like "Silk Silver" with a metallic sheen. It's not, but it's not the product's fault, I just misread the description. (I'm new to 3D printing). The thread is only light gray. It's fine for everyday typing, but I wouldn't overstate it. Now for the thread itself: it was vacuum packed with a desiccant bag, so it arrived as fresh as it came from the factory. I used over half the spool and printed everything from rough prototypes to miniature action figures.