Review on Ryobi Battery Holder: Efficient 18V Battery Storage and Wall Mount Solution by Dave Rasic

I like it, but I have a few recommendations. Thanks for turning on the hardware! If it was $12.99 I would buy 2, $17.99 - it's a bit pricey. A few design tips - I cut my finger unboxing, the edges are sharp. A bit of sandpaper around the edges very quickly after you take it out of the printer would be great, or maybe the design could round out the edges? On the back of the screw hole, the part that faces the wall, it would also be great if you could make the hole slightly larger than the size of the anchor head. For MY installation one side wasn't a problem, on the other side the wall anchor wasn't perfectly flush with the wall due to a small obstruction in the wall, obviously NOT your fault. This of course makes one side of the shelf not fit the wall, that's the side I can see so this annoys me. If the hole were lightened slightly this would allow the anchor to go into the relief and the post would be flush . These are small details that I know, but if they were taken into account in later versions, there would be nothing to complain about :^)