Review on 🔑 Convenient Keyless2Go Replacement: New Uncut Transponder Ignition Car Key Y164 (2 Pack) by Kris Martin

One key worked PERFECTLY and passed sentry programming. The second key wasn't programmed - it had a bad chip, which sometimes happens, as other Revain reviewers have pointed out. This was on a 2017 Jeep Wrangler. The programming process is not that difficult - you will need the two original key fobs that came with your new car. You can program up to 8 new Sentry keys without the help of a dealer. After that, you need to contact the dealer. We called Keyless2Go customer service at (516) 962-1755 (www.internationalkeysupply.com) and they immediately shipped a replacement key and emailed the tracking information to our Revain. Account. We will update this rating to 5 stars after successfully programming the new key. chip program. Jeep programming sequence. If you have two valid Sentry keys, you can program new Sentry keys into the system as follows: During this procedure, ensure that all additional keys are within arm's reach of the steering column. The back seat is a good place to keep your keys in a row. Don't lose track of which key is which. Also, never start the engine during this sequence.1. Cut the extra Sentry key blank(s) to fit the ignition lock cylinder.2. Insert the first valid key fob into the ignition switch. Turn the ignition key to the ON position for at least three seconds but no longer than 15 seconds. Then remove the first key fob.3. Insert a second valid key fob into the ignition switch within 15 seconds. Turn the ignition key to the ON position. After 10 seconds, a beep MAY or SHOULD NOT sound. Also, the vehicle security light will start flashing and will likely continue to flash until you leave the second key fob in the ignition. In any case, remove the second key fob after about 15 seconds.4. Insert a blank Sentry key into the ignition within 60 seconds. Turn the ignition key to the ON position. The vehicle security light MAY start flashing. After 10 seconds, a beep MAY or NOT sound. Also, the vehicle security light MUST NOT stop flashing, it will keep flashing as long as you leave a new key in the ignition. indicates programming is complete when the vehicle security light stops flashing, it should come on again for three seconds and then go off. This probably won't happen, but the new key was most likely programmed anyway. Take a trip to the drive to see if it works. The new Sentry button has been programmed. During this process, the Remote Keyless Entry (RKE) transmitter is also programmed.