Review on 🧲 Flexible Magnetic Phrozen Monoprice 135x75mm by Victor Olsen

Installation went well thanks to a 3M magnet that sticks firmly to the standard build plate and the magnet seems strong enough not to budge in the middle of the print and to create the shift shift. My problem is that even after adjusting the home position and z-height, I can't get the print to stick to the new plate. Without the plate, I had very strong adhesion, to the point of breaking prints trying to get them off. What I noticed about the plate is that it's so smooth that the print doesn't stick. On one hand I tried using sandpaper to scratch it as suggested in the review which seems to have been removed or the store page reset but that didn't seem to work. If I could get it to work the rating would be much better but the grip on the print is poor as it looks. If anyone has any suggestions that would be great, it looks like I'll have to order a new build plate or remove the magnet (probably breaking it because the grip is really strong). I use Elegoo Mars Pro