Review on 🔘 Ogrmar Plastic Dustproof IP65 Junction Box Enclosure (8x6x4) – Ideal for DIY projects by Craig Waters

I bought a 6 x 8 x 4 inch box to make an electrical junction box for a generator. I used a GreenLee puncher for duplex sockets. Durability can be an issue. Pros: Wall thickness is pretty good, measuring 3mm (just under 1/8"). Sealant is pre-loaded. Plastic lid screws hold the lid securely. Lid screws are captive. Plenty of internal screw bosses (which I haven't used) It can be messed with attached to the surface using the gussets/tabs on the lid without drilling the inside Cons: ABS construction, mainly S (styrene) content This makes it brittle I was afraid it would break on impact but it almost held up 1/2" less than stated with each measurement. The lid screws are made of plastic, which makes me doubt their durability. No information on screw sizes for the bosses or brass studs on the sides. Overall I am satisfied with the project box. It works as intended.