Review on GM Genuine Parts Rear Power Sliding Window Regulator and Motor Assembly - Reliable Replacement for Optimal Performance by Loren Jacobson

Part just what I needed! Usually the problem is not with the engine, here it is sold. Read other answers and reviews on installation. Remove both rear seats after separating them. Remove the 4" wide molding under the window. To remove the long section, remove the pulley from the end and then run a thin wire through each side of the seat belt buckle. Slide the strut forward a little to close it You will need to follow the same process to install the new long cable. Pry up on the pulley to reinsert the cable jacket into the pulley. First you need to work on the driver's side. into the metal clips that hold it. Guide Insert the pulley into the end of the window rail with a twisting motion. Slide the cable towards the window, making sure it is under the black plastic clip on the rail. Window. Now work on the aisle side. First insert the ball in the window and then insert the pulley into the end of the frame, you will need to pull hard to get the pulley through the end of the frame to get ns. Install a new clamp to the right of the pulley Insert the bottom of the drive pulley into the carriage frame and then (after removing the yellow bracket) insert the bolt to tighten the drive pulley. Reinstall all trim parts and seat. Be careful not to break the anti-rattle elements on the seat brackets. Lubricate the window rails to prevent the window from dragging, which could cause the drive to fail again. Actually I did this step first and opened and closed the window by hand to oil it.