Review on YOYI 3D Printer Filament - PETG 1.75Mm 2.2Lbs(1Kg) Spool, High Accuracy +/- 0.03 Mm, 100% New Raw Material! by Kenneth Broszko

It is a great filament, honestly! As another stated, there is a large difference between CHEAP and INEXPENSIVE, this is not by any means a CHEAP product, it just doesn't cost a ridiculous amount but performs along side those that do. I have used it for "pretty" pieces as well as parts that I NEED to be sturdy. I went through this Kg a lot faster than i expected which says a lot. I was basically was looking for excuses to print with it because it is such an attractive color and so easy to print with. PETg filaments are typically very stringy, this one not so much. For ME, i would run between 215-220. Doooooooown at 210 and i lose the clarity/transparency. Anything above 220 and it was basically boiling out of the nozzle, even at 220 it was a bit too pliable still do you can either up your parts cooling fan or turn down the temp. I will not only buy again (already did) but absolutely recommend.