🛠️ 14-Pack Double-Sided Spot Weld Cutter Sets: 3/8" HSS Spot Weld Cutter Remover Drill Bits with Hex Sheet Metal Hole Cutter Remover for Power Drill Spot Welding Review

Does what it's supposed to. review update. I've used them about 6 times and the shaft is worn making the knives difficult to put on and take off.

I used HF spot welding tools and broke both tools within minutes. The cutting teeth on these tools are very sharp and will not break. I'm very impressed and have plenty of vinyl cutters left over to use on other projects.

I've been using these for a few years, honestly can't tell if I've ordered the same ones, but they all seem to work about the same, these feel the same as the ones I've ordered before nothing really super special to say about them. Great how and why car repair videos on You TubeThe Clay Way

I bought this because of all the great reviews unfortunately I can't say. About half the bits were brittle and self-destructed once the bit touched metal. When they broke they looked like pot metal. The other half cut normally but wore out to bumps very quickly. Weird, like some are buggy and others not so bad. I didn't overload them, I used fat. They just don't live up to the reviews...

This torch did exactly what it was supposed to do. I see a lot of negative feedback on point cutters. The key to this is to limit lateral movement by drilling a small pilot hole for the center pin. You also need to keep the drilling speed low or you will wear out the cutting head prematurely. As a test, I wanted to see how many spot welds I could do with one nozzle. After about 40 spot welds I noticed that it cuts a bit slower. As a further test, I wanted to see if I could sharpen the cutting…

To properly use this product you will need a pointed tap and a 3/32 inch drill bit. Use a tap to score a point in the center of the spot weld. Next, place the drill on the threaded spot tip on the spot weld and drill a pilot hole through it. Then switch the drill to a spot welding tool. You want to cut through the first layer of metal but not the second layer. This way you can use a hand chisel (or pneumatic chisel) to separate the top layer of sheet metal that needs to be replaced. were pretty