🎨 Scotchgard Clear Paint Protection Film Roll - 3M - 12" x 96" - Bulk Size Review

Yes, I've seen YouTube videos on installation. I had all the necessary tools, soapy water, etc. I measured, marked the location lines with tape, and started. 1/2 gallon of sweat later I put it in place. He will find detours to commit to "himself" if he stretches a little. I finally turned on. I ended up with a few tiny bubbles and at least five creases along the edges as marks from an inexperienced installer. THIS IS OK, just looking closely reveals a C install job. Go, but be patient and take…

I bought this film to protect my car's bumper, front bumper, headlights and grille emblem for a Lexus. It took me about 1 hour to assemble the rear bumper. I took a piece about 8 inches thick and covered most of the affected part of the bumper, the pattern would look like a ']' bracket at the top. I've had it for almost 1 year and so far it's holding up with no damage or yellowing. I expected yellowing to be an issue since my car is white so I'm glad it's still clean. You can see the edges of…

This item is great but takes a long time to put on. Getting it right is a skill, if not an art. Also, at only 12 inches wide, it almost guarantees that you will most likely have a seam on the front bumper. For these two reasons I gave it 4 stars instead of 5. The hood was light, the door sills and trunk edge were good, the front bumper was annoying and the mirrors sucked. For the 2015 Mazda CX5 it took 2 orders of 12"x96" material to do all of this. I honestly have to redo the mirrors. There…