Set of 3 High Speed Steel Blades - 100 Teeth, 2 inches, 3/8 inch thickness - Perfect for Mini Miter Cut Off Saws Review

It would be ideal if the blade was a bit bigger to completely cut through the object to be cut. I had to finish the floor manually.

They are great for cutting brass tubing in bearings when assembling wooden clocks. I also use it for many dowel cutting projects. Bean

I like that they were very sharp, Did the job. Cut some thin brass tubing about 1/4" thick. They can get dull depending on how long I use them, but I liked the clean cut I was able to get.

I have never had to use these discs as I previously ordered a Hurcules mini table saw for pruning. The motor stopped working after a few cuts in small 1/2 inch dowels (wood). Neither Hercules nor Revain solved this problem.

I ordered this for my mini cut-off saw. Appears to be the same as the one that came with the saw. I haven't used it yet as it was ordered as a spare. I use my 5.56 brass saw to convert it to 300 black.

They seemed to hold up better than the ones that came with the saw. I carved the brass and the original was made in about 200 rounds. This has held up well. Possibly poor quality control with the regular blade because I was sure it was the same blade.

Blades are thinner than most blades of this type, not the worst. I couldn't get any of the three to just cut a piece of 11/32 x .014 brass tubing, upon close inspection the tips of the blade teeth had sheared off as if I were cutting steel. The blade that came with the saw made over 200 cuts, these couldn't make 1. I suspect it's an issue with the hardness of the steel used, due to poor quality control. Don't waste your time or money.