🏻 Powerful 6-Gang 12V Rocker Switch Box: Customizable Panel with 40 Amp Max, 12 AWG Wires, and 12 Volt DC Output for Auto, Marine, and More Review

Easy installation with color coded cable list. Of course, red power and black earth. The rest are blue-yellow and other colors 1 per switch. I have emergency lighting kits installed and use a switch to change the main lighting scheme. It works very well and was even used in a 58 car accident yesterday to protect me and my truck as first responders. Would recommend to anyone, I even have extra space because I don't need all 6. If you don't need 6 switches, just get a cheaper 4 or 5 button switch

THIS IS MUCH STRONGER THAN I EXPECTED! 20A FUSE. SMALL [COMMON] GROUND WIRE ONLY [THIS IS FOR LED CIRCUITS, NOT SWITCHED CIRCUITS]. SO PLEASE NOTE THAT THEY MUST EITHER BE EARTHED TO THE FRAME OR CONNECTED DIRECTLY TO THE NEGATIVE SIDE. SWITCH SINGLE POLE. <-- IF I SAID THIS FIRST, WE COULD STOP HERE. I control the following LED stuffs: a warning dial, an off-road fog light/flood dial, low [52"], 3 working/flooding, 2 angle points, 1 high point/current filling is not a problem because this…

I would give the 6 block block 5 stars but I only had it for a short time and only had 2 accessories connected to it. The quality is excellent. Secondly, the dimensions of the wires correspond to a load of 20 amperes. Third, the switches appear to be of good quality. I installed this sidexside in my new Honda Pioneer 1000 5 LE. It requires a bit of wiring know-how from the switches to the busbar or accessories, but it comes with fairly basic instructions. I'm not surprised it's out of stock, I…

Excellent quality and super handy as it comes pre assembled and color coded. The problem is two 40A fuses. You definitely don't want to draw 40 amps through these switch legs or through switches rated at 15 amps. Change the fuses to 20 amps (or even 15 amps). You do NOT want a shorted light strip to cause an electrical fire in the switch legs or in the 12 AWG wire that powers the 3 switches (12 AWG wire is rated at 25A per the DC Wire Capacity Charts). So basically you have 3 switches (x 2)…

I needed something to control the strobe lights that were on my Magnum lighted headache shelf with the ability to add other lights so I ordered this junction box. I didn't install, the guys from the shop who installed the headache shelves hardwired it and hooked up the strobe lights to switch F. Since the box is already connected to the battery, it will be easy for me to connect the spots, bays. and yellow beacons to other color-coded switches. The box is small enough not to be in the way, but…

This junction box saves a lot of time. It comes assembled with main power cables and fuses installed. The 6 auxiliary wires are marked with small cable ties that match the markings on the front of the box. I took the box apart so you can see what it looks like inside. I always test something prebuilt to make sure it's in good condition before installing it. As you can see the internal wiring is divided into two groups of three 40A circuit breakers for each group. The 12 gauge main power wires…