🛡️ Shielded Greased Miniature Bearings with 8X22X7 Measurements Review

Failed to load media. I bought these to replace a fully seized bearing and as they came in a pack of eight I figured I'd replace the other two. As you can see in the video, all three spinners work without friction and move absolutely freely. Only time can tell. how well they will fare in the elements. If they are anything like the jammed one (a rusty looking weirdo in short) then it took 4 years. Crossed fingers!

Were bought for the Bissel handheld vacuum cleaner. My mother's vacuum had a broken belt, so I put in a different one. The vacuum didn't pick things up properly so I looked again and the new belt was broken too. During disassembly, one of the roller bearings on the rotating brushes seized, causing the drive shaft to rotate but the belt not moving, causing it to overheat and break. I tried to find new camps locally but nothing came of it. Bearing size was on an old stock and luckily I found it…

I bought these because I needed 2 of them for 3D printing. The purpose of the print was to create a clamp on any spool of filament where two conical parts fit together to accommodate any inside diameter of the spool. These bearings were used at both ends to allow free movement but not too loose. If your spool ID is large and the spool holder (which came with my Ender 3 Pro) very small, this can cause friction issues if the line tension is not strong enough to overcome the friction to get the…