🔧 Enhance Steering Precision with GM Genuine Parts 23232310 Steering Shaft Torque Sensor Review

I installed the sensor. Then the steering wheel turns all the way to the right, I drive the car by just holding the steering wheel the whole time.

Knew it was used. The pin has already been pulled out. Installed as a last resort. As soon as the car started, the steering wheel turned to the left on its own because the sensor pin was pulled out and turned. I bought another one and solved the steering wheel vibration problem.

The sensor is new and yes you need to calibrate the car to center the steering wheel or it will be like the mind is turning the steering wheel why everything is correct but after i calibrated it it no longer pulses or just shuts off the power amp motor, this is also an OEM part, my box came with the GM logo on it

Works great Glad I looked into the issue before purchasing the power steering motor. This saved me several hundred dollars. I'm an average dye master learning as I go so it took me about 5 1/2 hours to remove, replace and reassemble them. This includes a lot of brain damage. But it would cost more than $500-700 if I brought it to the store.

My dad's power steering module which is the power steering motor and power steering broke down and the car stalled completely. This is a known issue on some GM vehicles. Since the whole car stalled, we also had to replace the power steering shaft torque sensor. I ordered it from Revain and it came right away. This is a GM OEM and it works great!

After installing a new steering wheel sensor found that the steering wheel turned fully to the right, the steering wheel lock itself did not until the sensor was replaced. The car no longer runs. I missed the short return window by a few days, so I'm out of $130 and the car is dead. Seller please contact me if you can make it right and send me a new one in exchange for the broken one. The car belongs to my father-in-law, an elderly man who has to drive to doctor's appointments.

I replaced this on a 2009 4 cylinder Malibu. I noticed that when I entered information about her car, it said this part didn't fit. This is the correct sensor for a 4 cylinder engine with electronic steering. Before you start, to be on the safe side, disconnect the negative pole of the battery. I didn't drag the whole column as mentioned in some reviews, you don't really need it. You can pull out the top half of the column, not the bottom where the motor attaches. Once you have removed the…

The power steering worked for 5-10 minutes and then stopped working. When stopping, the steering wheel shook slightly. This solved the problem and now I have power steering again. I didn't have to reprogram my car. Here are some tips I'd like to know before I jump into them. assembled sensor. Unless you have very large snap ring pliers, don't start this project. I didn't know how wide it was before I started and figured the snap ring pliers I had would do. I ended up having to improvise and…