AFA Tooling 40 Pcs Replacement Bumper and Fender Clips for Honda and Acura - Strong POM Polymer, No Breakage Like Nylon Rivets, Fits Selected Models Review

Perfect fit for 2004 Honda Pilot fender holes. It seems even more reliable than the original rivets. Remember that you will need both 8mm and 10mm plastic rivets depending on where you are installing them. I don't remember exactly where between the fenders and fenders, but I know I needed both sizes.

Much cheaper than the dealer and just as good. Stores never replace what they've lost or broken, leaving your lid rattling when you're driving or idling. Going to the parts store and trying to find enough of them can be a hassle and expensive. Great product and great price.

I work in an auto shop and every time I work on a Honda these stupid clips ALWAYS break. ALWAYS! They become brittle and hard and when removed they break or tear. So replacing the fender or installing the front bumper after the repair becomes a problem because the store doesn't have the right clips. So I bought them and increased my labor by 0.2 to offset the cost of ordering clamps not only for Honda but also for Toyota and Nissan. No business can do without a good range of body clips and…

They fit the front edge of my 07 Odyssey bumper. Note that you also need 8mm for the rest of the tread of the landing gear. The reason I gave 2 stars is because the design of these clips allows you not to press the clip without activating it. There are other clips on Amazon that have separate parts for inside and outside. This allows you to apply full force to the outer part and then push through the inner part. Because the inside is built into this clip, you have to try to press on the edge of

Ideal for the OEM replacement of most clips used to hold the plastic guards on the front of a 2006 Honda CR-V LX 2WD. The clamps are strong and seem to last quite a while. While the vast majority of plastic rivets used on Honda are 10mm wide. The length required depends on the number of layers of material to be held together. Honda offers 2-3 lengths depending on the location of the clip (bumper, fender, grille). To put it mildly, very confusing. They seem to work in most applications and due…

The tabs that need to be pushed into the notches on the center shaft (or push pin) to fit the hole just won't come up squeeze enough. Upon closer inspection (my phone can't take detailed close-ups without some crazy blur to help with this description. sorry) it turns out there is a tab that wasn't cut during the plastic clip molding process, this prevents 1 in 4 tabs from bending . I checked a few clips to make sure it was only one, but they were all like that. 3 fixes: 1) carefully file off…