🔩 Allstar Reducer Bushing, 3/4 inch Outer Diameter to 1/2 inch Inner Diameter, Steel Construction, Zinc Plated Finish, Sold in Pairs (ALL18567) Review

Suitable for fan gasket [automotive] and OD fits 3/4 hole in fan blade [flexible fan without clutch] '75 Monza 350 factory

This is a good bushing when trying to downsize from a 5/8" hole to a 1/2" hole. It is made of steel and can be sawn with a hacksaw to shorten it if necessary.

I bought molded rubber wheels for a handcart. There was play on both sides of the axle as the newer wheels were narrower. A few of them made it though I had to trim them to fit.

the case was the wrong size. I took a chance with them and they are perfect! Imagine someone making a piece of metal and knowing the real ID and Od! Thanks!

To fit fan gasket [automotive] and OD to fit 3/4 hole in fan blade [flexible fan without clutch] 75 years old, Monza plant, 350

This is a good bushing when trying to down bore from 5/8" to 1/2". It is made of steel and can be sawn with a hacksaw to shorten it if necessary.

Purchased solid rubber wheels for a handcart. There was play on both sides of the axle as the newer wheels were narrower. A few of them made it though I had to trim them to fit.

I've been to every hardware store in Phoenix, even the specialty stores, and all the 3/4 to 5/8 adapters, where it really doesn't fit It was the right size. I took a chance with them and they are perfect! Imagine someone making a piece of metal and knowing the real ID and Od! Thanks!