🔥 Harness the Power: HotRod99 Throttle Cable Bracket Billet Aluminum Black Anodized for 4150 Carburetors Review

Very good bracket but problem with the pivot that screws through the carburettor bracket and sometimes causes the throttle to stay open. I drilled out the carburetor and put a nylon insert in it to keep it from sticking, or better suited. But overall nice.

I fitted this bracket to my Edelbrock 1406 carburetor, it rubbed the gas a bit but I was expecting to have to change something. It takes a little time to get set up properly and get where you want to be. In general, the engine compartment is cleaned and looks much better. Happy with the product for the price.

This is for Holly carburetors but I fitted Edelbrock ABC2. If you drive an Edelbrock, you'll have to file the inside a bit to free up the throttle, but you won't notice it when you do. Suitable for square hole, not spread. High quality parts, very durable and nice packaging. Much cheaper than the same ones on the summit.

Easy to install and can be used with carburetor spacers to hold the throttle cable in place. Using this product solved this problem and allowed the throttle cable to be adjusted for proper operation from idle to full throttle. Recommended for aftermarket carburetors or fuel injection systems. Longer mounting bolts may be required for two positions.

I SEEN THIS HOLDER FOR $102.00 NO S###. WHEN I LOOKED AT AMAZON AND FOUND THE SAME COST FOR A QUARTER THE COST I PURCHASED IT AND WORKS PERFECTLY. I HAVE A SMALL CHEVY BLOCK AND HAVE 2 INCHES CARB AND IT FINISHES PERFECTLY.

Don't limit your intake to 4150 carbs! I ordered this for use with a Holley 4010 and figured I could probably get it to work. A little file around the front of the bracket next to the accelerator pump and I had a perfect fit. I later switched to an Edelbrock 1405 (not even close to the Holly design), the extra tray allowed me to clean the throttle body assembly without compromising the integrity of the bracket. Luckily, the material is relatively soft, so finding the right file is quick and…

Beautiful finish, quality materials and great price. Something to know, you need to use larger clearance on multi layout intake manifolds to make room for it. The throttle on a Edelbrock Performer/Avs series carburetor still won't clear, may fit into the ports without modification, but I've not tested. To attach it you have to hit the inside of the bracket with a sander and sand it down about 32 inches, which isn't a big deal but it will ruin the look of this show car part without heavy…