Amana Tool 45611 K Engraving Signmaking Review

As an avid DIYer, I was excited to try this router bit for my latest project. Unfortunately, it did not live up to my expectations. The precision was lacking, resulting in a lot of rework and frustration. On the plus side, it was easy to install and remove. However, I would not recommend this product for anyone looking to create high-quality, professional-grade pieces. It's better to invest in a better quality router bit for more accurate results. Industrial and scientific products should…

Probably a great tool. Too bad I broke off the tip with it on my first job. I've read reviews here warning that this is a fragile tip. So I used very low dive and feed/speed speeds, but apparently not slow enough. This tool is nearly useless for hardwood carving due to its very brittle nature.

Finally got to the project I ordered this nozzle for. Even after reading the reviews I decided to give it a try. With this information in mind, I conservatively set my channels and speeds to SUPER. Plunge 150mm/m, Travel 500mm/m, Doc 1.5mm. Cutting hardwoods Paduk and cutting board cherry. About 10 minutes after the cut I paused the project to check the tip and sure enough the tip was already broken. I'm not sure if there are any feeds and speeds that this bit could handle even moderately hard…