🔧 Amana Tool 47150 No-File Laminate Bit Review

This is a very good bit. It's tricky to set up, but once it's set up, you need to keep it in your power tool. It would have been nice if I had two routers when using this bit. The rest of the beat is great.

This tool has worked great on my laminate countertops and backsplash. I first trimmed them flush and then used this bit to finish. This got rid of a lot of the glue and I didn't have to file much or at all. It takes some time to set up, but it's not like a drawer lock bit, which is a lot harder. I've also used an extended base on my milling machine (prevents it from falling through) and it makes a world of difference. Fast and very smooth. You can make an extended base that isn't too hard or…

I can't fault the quality of this bit but I totally agree with other reviewers on the difficulty of getting the settings right . If you are fitting it according to the instructions provided, use the edge tape to remove the colored top layer of the laminate. The lower cutting edge below the radius portion is tapered. I think it would work much better if it only had part of the radius rather than a cutting edge between the radius and the bearing. But I was able to use it after carefully adjusting