🚢 Amarine Made 2pcs Stainless Steel Cup Drink Holder: Ideal for Marine Boats, RVs, and Campers with Convenient Drain Feature Review

Although I have yet to fit them they look great, the product is as described and appears to be of good quality. I wish they would list the drill hole size and recommended glue if available. I'll report back after installation and longer use.

3 3/4" hole saw fits well. I couldn't find this size to fit 3 5/8" and fit like a glove. I would go with a 3 5/8 hole saw, make no mistake. Great cup holder.

I had to wrap a few turns of electrical tape around the part that goes into the sofa so it was thick enough to hold it in place. Worked like a charm and way better than the plastic junk that came with the sofa. The top strap barely covered the transition from the leather sofa to the drink holder. But it hardly works!

What a compliment. The chrome hinges and bar holders next to it made it seem like they should have been stainless steel instead of plastic cup holders anyway. The adhesive on the bottom ensures it stays in place and doesn't deflate again when I tow, so that's good.

At work I welded a double cup holder using 4 inch steel tubing. This is quite a large size for a drink holder so that's all I could find. it would fit. I installed it next to my arcade cabinet on a bollard in front of my water heater. Works great, holds glasses and bottles great, but also fits in a big Big Gulp sized mug. The only downside is the adhesive is pretty weak but they fit well so it's not a big deal. This is enough to keep them from moving. Of course, when I show it to my brother…

I have a 14 foot V-shaped fishing boat and I always spill drinks when I move the boat on the water. I bought these to put next to my seat with my passengers in front. Installation was as simple as drilling a hole in the seat and applying some silicone around the perimeter of the cup holder and then dropping it into the hole. The holders have tape around them to fasten, but mine arrived twisted. I also felt that the tapes were too small to hold the holders securely. Otherwise the quality of…

You are great. 30 and 24 oz Yeti glasses are ideal, as are beer/soda bottles/cans. You will find it very difficult to purchase a 5 3/4 inch drill bit from local stores. This size was not available anywhere in HD, Lowes, Northern Tool or Harbor Freight. fits perfectly in a 5 5/8" hole. It's glove tight so you have to spray some WD40 on the outside and they slide nice and tight. Perfect fit with no sealant or sealant required. I have them in my center console is built in so I had to hose the…

They differ in that it is a marine product. Therefore, they must be 316 stainless steel or higher. Easiest to say? Attach a magnet to it, say 304 stainless steel, which is food grade, it doesn't have to be magnetic, and again, thanks to Revain, quality wins because they're non-magnetic. Oh, a note: if you don't know anything about saltwater and sea traders, try going to a store and appreciating them. If you don't faint when you see the price you're running away with, don't leave the store…