💨 ANVISION 40mm x 10mm DC 12V Brushless Cooling Fan: Dual Ball Bearing Efficiency Review

Recording outdoor video here in Florida can tax your camcorder since it's summer almost all year round. But with some of these fans, I can control the temperature of my camera and charge it with a USB power bank.

Ordered a replacement for a fan that had expired after several years in a VCR/Security Recorder. The fan is "always on" and all other devices in the room are OFF. You can hear this guy humming! It obviously makes noise because it WORKS and pulls out enough air for its size. Benefits: Moves air through the recorder and cools the device. strength for its size. Fair price, not flashy so I didn't expect it to be super quiet. Cons: Too bad it's not quieter. ?Rating: If I could test EVERY fan in this

I needed a tiny fan for my paludarium to keep condensation from getting onto the front glass without causing too much climate change. It's perfect! Fits comfortably in a small corner and works like a charm. Very satisfied as there is just enough wind for my 30" x 18" tank. My plants love it and so do I

This is a great fan that moves a lot of air. A bit noisy for the size, but that doesn't bother me. Although the one I got didn't have a ball bearing on the badge, I looked up the part number and it really is a double ball bearing fan. Great fan.

I bought this fan to upgrade my Ender 3's fan. I chose this fan because it is 24V and would be easier to install compared to Noctua. I measured the decibels of this fan compared to the stock Ender 3 fan and found it to be about 5 decibels quieter on average (measured at 1 inch and 1 meter). Overall a good buy if your Stock Ender 3 fan is broken and I want to buy something quieter with the same airflow and replace straight away. I also bought a 40mm Orion fan, which is also 24V and much quieter…

This fan is significantly quieter than the stock fan on my A350 PSU. I printed a modified backplane and this fan fits perfectly. Just make sure the pin wires match the correct points on the connector. I had to swap the red and black wires in the included 2 pin connector to get the power to work.

installed on standard Ender 3 hot end box. just fits well. had to be soldered into the wiring harness. it is slightly quieter than the standard hotend fan. However, this decline comes at a cost. the sound is higher and generally more disturbing. I'll try to get over it quickly.