💥 Enhanced Performance with APDTY 028144 Engine Knock Sensor Harness Review

Worked great. I replaced the knock sensors in my 2006 Chevy Silverado 2500 HD with a 6 liter petrol engine. The code is now gone from my check engine light.

I replaced 2 knock sensors, a new wiring harness and a new intake gasket, but now I got the code "Low circuit input" so he couldn't check it. I don't know where and why do I have this code?

Great product. Many have said that the wires between the knock sensors are a bit short. If this is the case for you, just remove some tape and reapply so they are the correct distance apart and they will work great. That's how I did it and had no problems.

I replaced this wire although I probably shouldn't have but removed the intake and replaced two knock sensors. The cable was glued in too far and had to be undone a little at the back (the green wire that is exposed). No big deal, just gotta know. Otherwise a good product, like factory. 2002 Silverado 2500 HD 6.0L

SERVICE AND FIND A DELCO DEALER! DID THIS IGNITION SENSOR LAST 8 DAYS? THE ONE WHICH WENT WITH THE TRUCK LASTED TEN YEARS"""" ((DELCO)) :::: SO YOU DECIDE WHAT YOU WANT TO PUT IN YOUR TRUCK? THE PRICE WAS CHEAP ENOUGH BUT IT WILL COST ME TWO HUNDRED TO INSTALL IT JUST FOR A WEEK OR SO? DO YOU WANT THIS CHALLENGE? AND NOW I HAVE TO BUY AND PAY MORE TO INSTALL IT. I THINK AMAZON SHOULD REMOVE THIS PRODUCT FROM THE """" JERRY NOVOSAD LINE

Bought half a year ago, finally installed last weekend. Cable length between the sensors is too short. I had to pull hard to get the connectors on both sensors. The next day the check engine light came back. Had to repeat the 3 hour replacement with seat belts from various vendors this weekend. went great. Driven several cycles and forty miles, the service engine light is off and the computer shows no malfunctions. When I inspected the Apdty wiring harness, a pin in the connector popped out…

If you need to replace the knock sensor, spend an extra $20 and get it. If your knock sensor breaks, the wire connector will also break. Many people say that the front sensor is fine and the rear is a bad sensor. Both of mine were bad, but the back one was a lot worse. If you want to cheapen it, cheapen it the right way and get the parts you need to get the job done right. Also buy ac delco knock sensors. You can buy super cheap aftermarket parts, but everyone says you should buy good ones…