🔌 APDTY 015333 Injection Pressure Sensor Pigtail: Replacement for 5C3Z-12224-A, 1832022C92 Review

My ICP was leaking and my old connector was filled with oil. I cut it off and replaced it with this one. It was a good game. The fact is that the wires are all the same color, so you need to be careful when connecting them. See my picture for installation. I didn't use creams. I soldered and used heat shrink tubing with glue inside

I was surprised at the quality and gauge of the wires on this replacement plug. I used it for IPR on PowerStroke 03 6.0. It worked out great and the truck is still rolling down the street somewhere. Folks, don't forget to solder this connection instead of those cheap crimps.

Worked great (ended up with an ICP sensor, not a pigtail, but that doesn't matter). I would however like it if they included a piece of paper in the box stating what colors on the original harness and when to which wire on the new connector.

Definitely lots of pigtailing with this fork. However, you should definitely buy a Ford ICP sensor and not waste your time on anything else. It cost $150 from the dealer and was in stock. Remember to make sure the old ICP o-ring came out with the sensor. If there is oil in the spark plug, replace the stem. As for bulletproof with protection, I would like to give some advice to owners of 03-04. Either buy it or find someone with a "spark plug boot boot". You only need one. Then get a piece of…

I was surprised by the quality and gauge of the wires on this replacement plug. I used it for IPR on PowerStroke 03 6.0. It worked out great and the truck is still rolling down the street somewhere. Folks, don't forget to solder this connection instead of those cheap crimps.

Worked great (it ended up being an ICP sensor, not a pigtail, but that doesn't matter). However I think it would be nice if they put a piece of paper in the package stating which colors are on the original harness and when on which wire on the new connector.

Definitely a lot of braids with this fork. However, you should definitely buy a Ford ICP sensor and not waste your time on anything else. It cost $150 from the dealer and was in stock. Remember to make sure the old ICP o-ring came out with the sensor. If there is oil in the spark plug, replace the stem. As for bulletproof with protection, I would like to give some advice to owners of 03-04. Either buy it or find someone with a "spark plug boot boot". You only need one. Then get a piece of…