🔧 Assenmacher Specialty Tools 200-8: Efficient 8mm Stud Remover & Installer Review

The tool worked for one screw but slipped on the remaining 3 which I had to remove. Not very impressed, probably worth going for a more expensive brand if you plan on using it a lot.

works as expected. There were earlier ones, but over time the rollers broke. Bought through a Snap On Tool distributor and was told there was no guarantee.

I bought this to remove the studs on my RX 300's motor mount. This one is smaller than the ones you can get at your local parts store. It worked much better than the kit I borrowed from the parts store. They just slipped off the bolt once you applied torque to them. It didn't slip a millimeter. He quickly got to grips with these bobby pins. I think that's a great price for a special piece.

Bought this tool to remove a stud from a Highlander 3MZ-FE engine. For anyone interested, this is an M8 stud with Toyota part number 90126-08012. The installed 99mm bolt has 13mm of open M8 threads outside of the motor mount (not counting the extra 4mm for the E8 tabs at the top), just enough for the bolt remover to "bite" the bolt a bit . The short 12mm thread that screws into the motor is factory coated with blue threadlock compound (Three Bond 1324 or equivalent) and the bolt torque is 11…