AutoRocking Separator Airbrush Moisture Compressor Review

Housing made of metal and acrylic. Strong build. The handle is plastic, but so far I'm not too concerned about that. Does the job and installs easily. The best are the oil and water filters. No need to look for easily lost parts.

No matter how much teflon tape I wrapped around the threads or how tight I screwed the regulator it bled like crazy the only reason I'm not returning it is because I'm filtering out a part had to do some jobs, at least that part worked for me.

I had a problem installing it on my airbrush. The adjustment knob would not stay in one position and was constantly letting air through. I disassembled the valve stem and found that the o-ring is too small. Oring replaced. Works perfectly.

The small bolt holding the air valve is easy to loosen. When mine fell out I couldn't find it. Had to go to a local store and buy a regulator off the shelf as I couldn't control the air with this product. It was on the silver button on the side of the controller.

Breathable like crazy from the upper thread. Looks like he's about to turn back here. The only way to reduce air leakage is to hold the filter firmly against the air gun. I put teflon tape on the threads of my air gun and on the air hose connector. i will return it

Compression thread leaking on conical type. I used a piece of tubing to make a seal on a 1/4" NPT M fitting. Sealed. Thin piece on top thread that wobbles. It's smoother and slightly breathable. Valve stem seal wrapped around the connection outside and a bit wire screed.

I bought this POS last June for a planned project. The project did not materialize. Yesterday I had to paint some base cabinets. I have 5 spray guns of different brands. This POS does not match any of them. The female-threaded upper part cannot be connected to the male-threaded connection on any of the guns. Beware of potential buyers. you have been warned