Beler Fitting Connector Fulfilled Hermeshine Review

I bought this to use as a selector valve between the main and reserve fuel pickup, but although the hose barbs are made for 3/8" hoses the hole size on the internal ball valve is only about 1/8". I've never seen a valve that didn't fit completely inside the ID. Be careful with this valve as with a nominal 3/8" ID it won't leak.

This is a regular product, the valves are pretty cheap and don't hold onto the breakpoints. But it works for what I need it for. Doesn't leak.

The part has fine brass filings as seen in the pictures indicating poor workmanship. The 2 nipples coming out of the Y ends are obviously threaded and should be sealed. It leaked when I first attached it and saw that it wasn't fully seated. The hand is still firm.

I bought this to use as a selector valve between the main and reserve fuel intake but although the hose barbs are made for 3/8" hoses the port size is on the internal Ball valve is only about 1/8 inch. I've never seen a valve that didn't fully fit the ID. Be careful with this valve as with a nominal 3/8 inch ID it will not leak.

Bought this valve to control the gas from two gas tanks to the engine. When I first installed one of the valves, the knob rotated but slipped off the valve stem and damaged the plastic knob. I was able to get it to work temporarily by tightening the screw that holds the handle (IF YOU BUY, TIGHTEN THE SCREWS BEFORE USE). I bought a second of these valves to get a new grip. Yesterday the original valve started leaking at the valve stem with constant dripping so I replaced it with the second…