🚤 BougeRV Waterproof LED Trailer Lights, DOT Compliant Submersible Brake Marker Running Tail Lights for Under 80 Inch Boat Trailer, RV, Camper and Truck Review

I bought a kit for my 16ft trailer and they worked so well I bought another kit for my 10ft trailer. If you're tired of fiddling with lightbulbs that never work due to corrosion or shock, then this is the answer. These lights are really bright and easy to install. Only three wires are involved. The white wire is grounded, leaving only two to connect to the running light and brake light. The total installation time was about thirty minutes.

I've only had them a few weeks. Easy to use and super bright. This summer I already have the third light on the boat trailer. The rest wasn't from Revane. Definitely don't waste your time on anything other than LED lights that are submersible even if you don't intend to go underwater. Others corrode quickly and light bulbs burn out quickly. There's nothing worse than being out and about fumbling around looking for lightbulbs and trying to get them to work. I am completely satisfied with these…

I bought these to hook up to my trailer to replace the original normal bulbs. These were the same screws as my original lights and even worked with the original license plate bracket. The wires are really long and they had about 5 extra feet that I don't need for my 5 by 8 foot trailer. The only problem was that the ground wire is very short so I had to drill a hole to attach it to the trailer for grounding. I wanted to make them a temporary magnet set but found it easier to just bolt them on…

They have been on my JetSki for two months now. They started out strong, beautiful and radiant. I've ridden JetSki about half a dozen times since noticing its lights yesterday, one of the lights had dropped to a single LED. Upon further investigation, it turns out that both taillights are half filled with water. Maybe this is just a coincidence hoping the seller will do the right thing and exchange them. Will update my rating depending on the seller's response. UPDATE: After contacting the…

I have a 4" x 10" cargo trailer that needs a headlight replacement. I bought this kit because I didn't need side marker lights, just two tail lights. They fit the same bolt pattern as the originals, so all that was required was to cut the existing wires and run new ones. Older flashlights didn't have a separate ground wire; make new ones I soldered the ring connector to the white (ground) wire and used one of the mounting studs as ground. Works well after a month of use. Note. I soldered the…