🌊 Briidea Hi-Lo Sump Pump Controller: Dual Float Switch, Overload Protection, Black – Enhanced SEO Review

I put this in my aquarium sump as a failsafe to keep my tank from overflowing when my overflow might be clogged. is out of the water and thinks the bottom sensor is useless. So as soon as my high water sensor runs out of water the pump turns off, as soon as the high water sensor is back under water my pump turns on again. I still give it 4 stars as it does what I want but couldn't. Giving 5 stars because it doesn't work as advertised. UPDATE I understand why you need a low and a high sensor as…

I've spent so much money on Wi-Fi, Z-Wave, Zigbee leak detectors. I had to return or replace half of these and they still didn't work! Many of them will detect the leak, but none of them will send a signal back to the app or hub. I'm so glad I finally found this solution, it works great. I only have two complaints. First: I wish there was a Wi-Fi component so I could control it remotely if needed. Second, it has a failover feature that worries me. It keeps the pump running when it's been…

Both sensors are yellow, they are identical, not red/black as stated in the instructions. It is impossible to tell them apart. Installed as instructed and cycled the pump and only one sensor worked. He turned on the pump, and when the water supply lever was lowered so the sensor was out of the water, the pump turned off. A ground wire was added to the tank as per the instructions and it really worked for about five minutes. Light up when both sensors get wet and go out when both are out of…

My 15 year old Little Giant 5.5 ASP drain pump stopped working through the float. After spending $50 replacing parts and getting more and more frustrated, I finally found and bought this thing. Really easy to install so far and after a few rains it works great. There are only 2 minuses, because you need to figure out how to put the pump in always-on mode. I just lifted the lever and tied it down. Another disadvantage is that small sensors can be a bit awkward to mount with cable ties. The ones…

MAX 16 AMP Draw. :( I LOVE the adjustable sensors. The plug is poorly designed and covers almost every outlet on my UPS. This will sound an alarm if your pumps fail! It will sound an alarm if your pump has been running for more than 20 seconds. if your pump not working or if your pump is drawing more current than a certain level.The second mistake (IMHO) is that they wrap the wires to the sensors left to right instead of in a loop, which causes kinks in the lead wire.I have just put the ends in

Update 3: It worked fine for a couple of weeks and then enough sediment built up on the sensors to disrupt the electrical current and cause erratic operation. Disappointed. Update 2: I called a plumber to install a custom drain for my water softener so I decided to try again. So far so good for 1 week. The only question is how it will hold up in the long run. Will be updated when it starts to fail. Update: I have (unfortunately) found that this device is not working reliably due to the water…