🚐 RV Camper Trailer 4-inch Square Rubber Bumper Plug End Cap Cover by Automotive Authority Review

It was a little too big for our 2012 Fleetwood E4 camper but my husband managed. He was fine as he said it was the end that would be permanent.

It seems a bit big. I ended up using a rubber mallet to hammer it in, after all I don't usually take it off this end so it will work for me.

We ordered this to replace the bumper plug that originally came with our motorhome which came loose while driving. We ordered 2 replacements - they fit snugger than the original.

I was concerned about the material and if it would stay in my 4x4 bumper. It will not fall to the street like the original block.

Super snug on first wear but I think it's good considering my originals would be so snug I wouldn't need to buy them. Time will tell how well it will hold up, but it looks like it will stay.

This is a standard connector that has been around for many years. This is hard rubber, clean, no burrs. It's a little difficult to install, but it settled with a few hits with a rubber mallet. That means it won't come out that easy. A good product.

They fit snugly as others have mentioned but just make sure the cap is well aligned before inserting. I don't worry too much about losing these like I did with the original caps, so tight is better than loose. I lost my last one while camping due to a good cross wind. These baseball caps are good and look just like the originals, only with a more durable rubber construction.

As already mentioned, they seem a bit large. However, the material it is made of is much better than plastic. I boiled some water on the stove and then soaked them in water to soften them when first put on. The second time I put them on I applied some lube around the edge and used a light hammer. The third time just a hammer. Finally, now I can slap and dress them with my hand. Winnebago 26A bumper