Header banner
Revain logoHome Page
calorbot filament friction compatible printing logo

Calorbot Filament Friction Compatible Printing Review

3

·

Average

Revainrating 3.5 out of 5  
Rating 
3.7
🖨️ 3D Printer Parts & Accessories, 🏭 Additive Manufacturing Products

View on AmazonView on ЯM

Media

(4)
img 1 attached to Calorbot Filament Friction Compatible Printing
img 2 attached to Calorbot Filament Friction Compatible Printing
img 3 attached to Calorbot Filament Friction Compatible Printing
img 4 attached to Calorbot Filament Friction Compatible Printing

Description of Calorbot Filament Friction Compatible Printing

Highest Quality PTFE- Produced by professional PTFE factory. Our bowden tubes made from the finest pure virgin PTFE, so it always has good flexibility, abrasion resistance, chemical resistance. High Lubricity Additives-The lowest friction Bowden tubing on the market.more responsiveness, less retraction, more accurate prints, less slippage, wear, and tear on the extruder, and less clogging when printing chunky filaments such as some woodfills or ironfills. Lower Retraction-Saved every time the extruder retracts. Over the course of a print, a few milliseconds here and a few there add up to a lot of time saved. Compatibility-Compatible with all 1.75mm PLA ABS 3D printer. 1.9mm ID reduces the "wiggle room," or buckling, allowing you to print flexible filaments even on the longest Bowden systems. High Temperature Resistance-Heat resistant up to 280°C. Please get this PTFE tubing from Calorbot 3D Directly. "waskeefo" is a faker.

Reviews

Global ratings 3
  • 5
    1
  • 4
    0
  • 3
    2
  • 2
    0
  • 1
    0

Type of review

Revainrating 5 out of 5

What do you need! on 3D Printer Parts and Accessories

I highly recommend Capricorn as the best upgrade you can make other than one of my extruders (shameless plug). I usually stock shelves with it. Very durable material and slippery. Heat resistant and just what you need. A recent shortage forced me to shop online. The seller is gone! I recommend this item and the seller. Thank you!

Pros
  • 3D Printer Accessories
Cons
  • Legacy Model

Revainrating 3 out of 5

Get this only to replace the white tube on low temperature printers.

I tried to use this on my Qidi X-Max and Qidi X-plus. Using PETG at 250°C in a direct drive system. It cannot withstand these temperatures for long. it deforms and clogs too easily. I was hoping this would work near Capricorn, but it doesn't. Spend a few bucks more if you need consistent performance and have a Capricorn.

Pros
  • Additive manufacturing products
Cons
  • Some little things

Revainrating 3 out of 5

Terrible Packaging: 3D Printer Accessories

The tubes come in two tightly rolled rolls. By "tight" I mean about 2 inches in diameter! This gives the tube a tightly rolled set that is difficult to remove. Surprisingly, one of the coils was not twisted. The other had two creases from trying to roll it to the smallest size possible. I was able to straighten them out enough to be usable hence 3 stars. There are better alternatives.

Pros
  • 3D Printer Parts and Accessories
Cons
  • New Competitors Emerged