🔨 9-Piece Abrasive Mounted Stone Set for Dremel Rotary Tools - Grinding Stone Wheel Head | Dremel Accessories with 1/8 Inch Shank | Carving Expert Review

They arrived quickly and in good condition. They have been a welcome addition to my rotary and flexible shank tool in my leather projects.

I use them to sharpen knives and lawnmower blades. It works much better than my knife sharpener. Holding the knife straight, I run the Dremel along the edge of the blade at about a 20 degree angle.

Bought these to clip my dog's nails. They were so clogged with nail debris that they lost their effectiveness. After purchasing the styling wand I've been able to keep the stones nice and clean and they work great.

Everything was fine. I'm not sure if they're meant for aluminum, but they're not very good for it. Before you get too far, it absorbed the aluminum and became smooth. I used a brush on a bench grinder to clean it up and then repeated it over and over again

When I opened the BAG they arrived, one of the cylinder jewels was broken. Anyway I had 2 left. I started using one to mix 2 pieces of metal together and after a few minutes it broke and the pieces flew everywhere leaving only the mandrel in the dremel. I wouldn't trust that

yes of course they can grind as they are held together for a VERY short time, the binder used to hold the stone on the shank awful insufficient and when heated quickly breaks and turns into a granular powder and will not bond making it useless for anything other than warm oil if you intend to use it on metal forget it it will NOT stick together. If they REALLY fall apart you can always glue them together with JB Weld 8281 which should hold better than the glue you used. ,

These little guys work just as well as brand names but for a lot less money. I only use them with metal so I don't care if they work with other materials. They hold steel very well. With aluminum, in my experience at least, molten aluminum tends to stick to the bits and form a shiny streak. These don't seem to do that. However, time will tell. If someone sells me a bad product, rest assured that I'll throw it on the internet as often as possible, so you can count on me to update this review if…