🚚 Caterpillar Ultra Tough Truck Tailgate Mat/Pad/Protector - Trim-to-Fit Rubber for Pickup Trucks 62"x 21" (CAMT-1509): Heavy Duty, Extra-Thick Universal Solution Review

Will not fit the new 2021 Dodge Ram body. Even with cuts, it just doesn't look right. A very thick mat leaves many edges open and just doesn't fit properly. can still come. and doesn't come with enough screws.

It really works, I've suffered a lot from gardening a lot and it still looks brand new. Easy to clean. When you install it, you need to make sure there is nothing blocking or interfering with the tailgate closing.

Great tailgate mat for the money. My only complaint, like others, is that I could use about 12 more screws. Before you say it, yes I understand that not every screw needs a screw, but I could use about 12 more screws. As you can see in the picture, my F350 door uses the entire mat, only the latch areas are clipped.

Decided not to drill holes in tailgate. I used double sided LLPT tape to hold the mat in place, I'll probably use screws later to attach the edges of the mat. I will be back in a few months to update the tape hold. I used a utility knife and regular scissors to cut through the rubber mat, an easy process. One star off because my first order didn't come with any screws. Although the exchange was quick and easy. Ford Ranger 2020.

I only gave 1 star because I think the customer service is poor. The product is great! It comes with 24 mounting screws along with instructions stating "The location of the screws in the illustration may vary depending on the brand of truck." Had screws to attach the inner panel. After several emails that I still need 6 screws, I even offered to pay for 6 screws. I never got a reply from them. Again, no complaints about the product, but forget about getting a dime!

I looked at a lot of carpets and they were all too thin for my use. I needed something to hide the curves etc on my tailgate to protect my knees. I didn't use the sheet metal screws that came with it as I don't use sheet metal screws in my builds. I drove 1/4" rivets into the tailgate body to secure it if needed. This mat is made from about 3/8" thick rubber so it will last for years. Slightly more expensive than the rest but that's ok, it is perfect for my needs I would recommend this to…

Just bought a new 2020 F350 and it fits almost perfectly. I ended up trimming about 1" on the long side and 1" on each side. There are lines to help you cut straight. Used scissors and it cuts easily. The only complaint is that the manufacturer only supplies 24 screws and I needed 6 more. I used some sheet metal screws around the edges where I needed the last 6. They stick out a bit so next time I'll use the same ones that came with the mat at my local hardware or auto shop. in the city. Note…

Put this product together for a new camera and object without using any material I don't need. Antes de comprarlo coloqué la marca, modelo y ano como indica amazon y este me dijo que servía y al final no queda bien. Seguí los Pasos del Fabricante de cortar los laterales sobrantes por el Lugar recommended pero ese no solo era el problem. Si lo pones como debe ir tomando en cuenta el escalón que tiene la tapa en su borde después la puerta no te cierra porque choca abajo con el borde del piso. And