🔌 Cllena Dual USB Socket Charger 2.1A&2.1A + LED Voltmeter + 12V Power Outlet + ON-Off Toggle Switch Panel for Car Boat Marine RV Truck Camper Vehicles GPS Mobiles (Blue) Review

Do you need a set of instructions or a circuit As I've found out, there should be at least one instruction with a switch. I couldn't find any + or - indicators on the switch anywhere. It's a little frustrating. Light is a light tab, I'm considering turning off the blue light switch and replacing it with an unlit switch. This is used in the camper to check the battery status when driving in the tramp and also when charging phones (etc.). Put it in a spare battery at home and left it on…

Excellent compact device. So far, so good. The instructions do not clarify the connection diagram, but the picture on Revain and the answers to questions clarify the correct connection. Average silver power (battery), end silver power (+) to (+) on each accessory, bronze ground (-) to (-). I first bought 12 gauge wire but it was too big for the connectors. I ended up getting 16 gauge and it worked. I also used splitters for the 2-1 connections at first (Figure 4), but only got 8 volts. I…

This thing seemed perfect for an RV. There was even a seat in my van that looked like it was made for this thing. So I bought it and then waited about 4 months to install it. I read a number of reviews that it was difficult to install and sometimes didn't work and people said it was plagiarism. That thing was about $16 or so. Who cares if it doesn't work. If you need this item, you can probably afford it within your budget. At least I haven't had any problems like that. I have read the…

This affordable panel is a great modular solution for boats and vehicles where extra performance is needed. The switch can be connected first so that when it is off, it shuts off any parasitic current draw from the voltmeter or buck converter in the USB outlet. These round threaded connectors are interchangeable, allowing you to replace the cigarette lighter port with an additional USB port. Sockets or whatever else fits. I modified mine and put in an XT60 plug to charge the RC multicopter's…

A beautiful product that requires some skill and skill to install in the partition. You will need to make a very precise paper template for the hole you are going to put in the wall. If you cut a little more, the plate will not be fixed properly with 4 screws. You will also need to purchase a jumper wire (I recommend 16AWG stranded wire) to connect them together. Follow the wiring diagram shown in the drawings. You can also have the meter turned on using just the main power switch and leave the