Description of π§ CMT 855-803-11 3-Piece Carbide Tipped Hardwood Set
Contains 3 bits: 1-5/8-inch ogee rail and stile bits and a 2-1/8-inch slot cutter. Use a rubber panel retainer to secure the glass in slot cut into the frames For hand-held routers. Make a square rabbet on the inside of your door for installing the glass panel. Non-Stick Orange Shield Coating, Anti-Kickback Design, Equipped with Bearing. 2 SinterHip Hi-Density Industrial Chrome Carbide cutting edges for long-lasting performance.
Bit set came quicker than expected. The set is perfect for my project. One of the camps started to fall apart but still managed to complete the project, not AMAZON FAULT. CMT email reported the problem and received a free replacement a few days later.
This was the answer I was looking for for putting glass in souvenir tables and display cases. Watch a YouTube video to get started quickly. Do exactly what they say and you will get it right the first time. Make your own wooden glass holders inexpensively. Don't diminish your beautiful work with an expensive rubber seal. I highly recommend this item!
Nice set. The only problem is that the glass dowel cutter is minimal and if you're using paper thicker than 3/4 inch (e.g. 13/16) your cut will be right on the edge and you may be left with small sheets that you have to cancel. If they made that cutter 1/4 inch deeper, this problem would go away. However, it's likely that most will only increase a little to fix this, but in my case I matched against an existing profile and couldn't do it.