🔌 Conntek 7-Way Trailer Cord with Junction Box – Ultimate SEO-friendly Solution Review

We have a 2016 4Runner and the trailer wiring connector is under the bumper. We had to get this extension as the wiring on our service trailer is too short to reach. I could have endeavored to extend the trailer's wiring, but that seemed like too big a project. This extension worked great and I just zipped it to the right length. The quality and finish is nice and heavy and I don't see any issues with it.

It's a shame that such a nice 7-way system has opposite wire colors. trailer brake line. The blue wire, which is ACTUALLY for trailer brakes, has red sheathing covering it and Conntek uses it as a stop/turn wire. colored sheathing for replugging wires. In addition, a very good setup at a reasonable price.

When installing the lights I struggled to get them to work. When I checked the signal I had a strong signal on the truck but nothing on the box - bad cable - the connector in the part was very loose, some pins connected and some not. I was too far into the project to stop, so I replaced the connector and cable in place. In case you're wondering, the truck is a 2019 Suburban and I have several trailers that work great so the plug and cord were the problem. New plug and cable, now everything…

If you are like me, buy all similar products and read reviews. In a short amount of time, and it should have taken hours, plus more expense than the cost of this article, to purchase a longer cable, remove the camper, rewire, and reinstall the camper on the truck. Measured and was two feet shorter, so I knew I needed at least three feet of extension. A local camping store had a Curt 4 foot extender for $59.99 + tax. I went with Revain and there were several options, it had better reviews and I…

Does what it's supposed to do. After looking at the distance from my original connection to where I wanted to install this extension, I wasn't sure if 4 feet would be enough, but it turned out to be enough. The fit (woman on truck, man on cable) was VERY tight on my 2011 Tundra. I would advise anyone contemplating a purchase to get some dielectric grease to make the process easier. My first attempt at connecting the two without greasing involved disassembling the pivot on my truck so I could…

Perfect length to extend the 7 pin wiring to connect to a van and trailer. The 7-pin plug is usually installed in the rear area of the body, where it is easily accessible for connecting caravans. Our truck's wiring came out the front of the RV and in this case wasn't long enough to reach the 7-pin connector at the rear. This extension was more than enough to get the job done. Wire gauge was varied (larger) in the sleeve for battery charging, grounding and electric brakes, making it the perfect…