CPU cooler ALSEYE H120D, black/RGB Review

In general, I am satisfied with the cooling, but if I knew in advance the nuances with the mount and the strange engineering idea for two coolers, I probably would have thought about whether to take it. One good person in the reviews noted that the coolers have different blades for blowing in and blowing out. It is important to properly place them or the cooler itself so that hot air is thrown out of the case. Under the cooler that in air, there is a sticker and a snowflake icon, they say…

Cool tower. Value for money, at first glance looks decent. A large "sole" area, two coolers, large radiators, six heat pipes - all this has a positive effect on processor cooling. You can't hear the fans at all. Installs very easily. Compared to the boxed cooler from the ryzen 5 1600, the temperature changed in idle by 10-15 in stress by 20-25 degrees

Pros: Quiet, beautiful (the backlight is just top), it blows normally. Cons: Attachments for an amateur. Large, making it difficult to install for the inexperienced.

Candid thoughts on this purchase.the backlight can be turned off mechanically by disassembling the fan housing, the ring on one side is held on by latches

Fastening (AM4) under the cooler, it is better to start each bolt one turn and put cardboard or paper under the fastening as in the photo, remove both coolers, so it will be much easier to hook the latches. Then pull out the cardboard and tighten the bolts and install the cooler back.

*I ran into a problem, possibly a marriage or maybe a design flaw - extraneous noise from the fan blowing out (the problem is not in the fan itself). Quiet enough without this bug. Made a video about this - www. Youtube. Com/watch? v=SeuIJJ-ovQ4 Inconvenient installation of the fan! I installed socket in 2022. First, I attached the radiator to the mount, but the screws did not reach 2-3 mm! Then I tried to tighten the mount a little but could not put on the radiator - it became dumb to break…

Its pros: Copes with its task well, a wide range of mounts for different sockets. Some cons: Works better with one fan than two. The blowing fan makes an unpleasant sound. I took it off and everything was fine both in terms of sound and cooling.

an excellent tower for these grandmothers, it works, cools, the cooler is normal, not very loud can be adjusted through the speedfan, but I went the other way and changed all the turntables, including the tower turntables, to 6-pin turntables with a connector. 3-140 for blowing, 2 -120 tower and 3 -120 for blowing, everything is good. in idle turn off the coolers and there is no noise. I advise the tower in this price range, it is super and the color is black and not bare metal.

Best tower cooler for the price considering design/efficiency/height/noise. There are no complaints about the cooler radiator itself - IT IS PERFECT! You can only replace the fans. Someone may not like the price, but it's worth it (I took it for 2600). Pros below: The cheapest cooler with 6 heat copper pipes, 2 4 pin turntables, good quality and appearance, excellent power dissipation, good height and will fit in most cases, fit on most sockets, the ability to connect two turntables to one 4…

Great cooler, reduced by 20%, for its price it's a great cooler I advise you to buy The quality of the material is excellent except for the fasteners :) Pros: A very beautiful cooler, it does not make much noise (almost no noise) during operation (socket 1200, Intel i5 11400 processor, there were no problems, everything you need was included in the kit Some cons: Bad fasteners, which are at the bottom of the cooler, their quality is not very good, you are afraid to break them during assembly.

In principle, as a temporary plug, it’s not bad, but it doesn’t take out its declared, although with such a price it’s not surprising, but still, it turns out they lied)

I’ll add on my own that it’s too hard for me to sit on the mount, the motherboard bends when removed, it’s as difficult to install as it is to remove

I ordered a well-known cooler from Ali, he walked for a long time and had to buy this one, he came with it, the quality of China is a hat, I never regretted that I bought this one. Got pros: Price, quality, convenience. In general, it’s hard to find a better one for such a budget, 2666 v3 lives under it and does not grieve, but has not yet done a turbo boost unlock. In the stress test I saw 62 degrees maximum. Has some cons: Everything is ok for its price tag, of course I would like to have…

There is no thermal paste, although it is in the photo of the kit and in the instructions. The amazon support service offers me to communicate with the supplier of the goods on this issue, acting only as a carrier. Unexpectedly somehow. The goods from this supplier - WITHOUT A WARRANTY, because. to comply with the warranty conditions for the installation of a cooling fan, the thermal paste of the fan manufacturer or recommended by him is required.

I have 5600x thermalright tfx thermal paste, zalman n5 mf case + 3 turntables on top. In auto mode, it "roared" a lot at the slightest load. In the stress test Aida 64 run for 10 minutes, the temperature is 74 degrees. "Roar" is corrected by adjusting the cooler speed through the BIOS: he set 40% rpm to 80 degrees. 80 to 90 degrees 50 rpm. Do not believe it, but the fact with the same stress test shows the same 74 degrees, BUT IT IS NOT HEARD 😁. Good luck to everyone in shopping and competent…

I do not deny that I did not quite correctly select the cooler for my processor and motherboard, but I was based on the declared characteristics of manufacturers, reviews on this cooler and compatibility. And as it turned out empirically - everything is even. Perhaps for weaker processors and larger cases, this cooler will come in handy. Has pros: Number of outlet tubes, very quiet, chic and rich RGB lighting Some cons: Disgusting mount for LGA1700 socket. Very hard to install. I had to first…