Header banner
Revain logoHome Page
creality 3d printer assemble exturder logo

Creality 3D Printer Assemble Exturder Review

3

·

Poor

Revainrating 2.5 out of 5  
Rating 
2.3
🖨️ 3D Printer Parts & Accessories, 🏭 Additive Manufacturing Products

View on AmazonView on ЯM

Media

(4)
img 1 attached to Creality 3D Printer Assemble Exturder
img 2 attached to Creality 3D Printer Assemble Exturder
img 3 attached to Creality 3D Printer Assemble Exturder
img 4 attached to Creality 3D Printer Assemble Exturder

Description of Creality 3D Printer Assemble Exturder

100% brand new and high quality. Tip of the nozzle, aluminum heating block, Throat pipe. MK8 Extruder Hot End kit, white wire was temperature thermistor, red wire was heating tube 12V40W. Material: Aluminum & Stainless Steel & Brass. Creality 3D Printer Full Assemble MK8 exturder set For CR-10,CR-10S.

Reviews

Global ratings 3
  • 5
    1
  • 4
    0
  • 3
    0
  • 2
    0
  • 1
    2

Type of review

Revainrating 5 out of 5

Quick Install on 3D Printer Accessories

After struggling with my old hotend, I gave up and bought this replacement. No fuse, easy installation replacement. Works perfect. It remains to tighten the nozzle and Bowden tube. Mounting screws are not included. I lost my original screws but I had spares on hand.

Pros
  • Creality 3D Printer Fully Assembled MK8 Extruder Kit For CR-10, CR-10S
Cons
  • Ugly Packaging

Revainrating 1 out of 5

Broken extruder spare part

I bought this extruder and it never worked. I contacted the seller and they never replied. I'm disappointed that Creality can make parts for extruders that don't work. The extruder temperature display on the control unit shows from 356 degrees, which is already above the maximum extruder temperature. It's very disappointing

Pros
  • MK8 extruder hot end kit, white wire was temperature thermistor, red wire was 12V40W heater tube.
Cons
  • boring packaging

Revainrating 1 out of 5

Replacing the thermistor screw causes a short circuit

This is the second replacement hot end I have received in a week. Creality changed the thermistor screw that holds the wire at the end of the holder. This new screw will break the cable's plastic coating and cause a short circuit. When you turn on the printer, the screen shows an error 325 max temp. If they had actually tested her before hitting the box, she would have been caught. Totally unacceptable for a third party company.

Pros
  • Material: Aluminum, Stainless Steel and Brass
Cons
  • Available in black only