🖨️ Enhanced Extension for Creality 3D Printers Review

I looked through 2 sets of these cables from this particular seller and the cables for the stop switch on all axles were bad on both sets. When attempting auto-homing, the machine thinks it's already homing shortly after switching to the switch (for all axes), or throws an error that requires a machine restart. Never had this problem and it went away after uninstalling the extensions. All of the other extension cords seem to work fine as I've been typing for hours while they're still there…

This extension set is a must if you need to move the control box beyond the original, very short distance. The reason I lowered 2 stars is because the quality check failed on this item as the person who crumpled it made a huge mistake with the X motor cable. It was the exact opposite and I almost broke my printer the first time I ordered home. He went straight to the right where there is no end-of-course sensor and struggled to continue even when stopped by the frame. I had to remount it for my

I just received mine and based on other reviews here I decided to test the cables with a potentiometer. All x, y, and z cables had their four wire connectors (they have six pin connectors but only four wires) properly connected. However, only one of the two cable connectors (these are three-pin connectors) was correctly connected. It doesn't matter much. You can push the pins out of the connector housing and quickly re-solder them. But the four-pin aviation connector is also cross-wired…