🚀 Enhanced Creality Motherboard: Customized Non Standard, Boosting Performance Review

Wonderful! I installed this upgrade board v1.1.5 in my Ender 3 pro and wasn't expecting anything more than quieter stepper motors and no salmon skin. I've got more. On cardboard 1.1.4 I extruded at 140% and 225°C with a layer temperature of 60°C to get a decent print. After installing update 1.1.5 I am now extruding in some slicers at 100% or 1.0 and my nozzle temp is 200°C and the layer temp is 50°C when I print with eSun PLA+ and the prints are really good. good thread. The salmon skin has…

So I installed the board and started printing. The printer is less than 5 feet behind me and I had to keep checking to make sure it was actually working. Gone is the WHINE motor, even from the extruder motor. Very impressed with how well this board dampens everything but the fans. However, I had a dead Z channel which caused some problems. I am sure this is not common. I returned the board and bought another board based on the opinion of someone who has such a board that it's also quiet, adds…

On the plus side, the 1.1.5 board's stepper motor drivers are quiet and plug-and-play installation. I checked the overheat protection, it works as it should on my board. It's been up for about a month now and hasn't let me down. On the negative side: Creality advertises that the bootloader is "preinstalled". This is wrong in my case. This board costs very little compared to other offerings and the pre-installed bootloader was a big selling point for me as I have a newer Ender 3 Pro which has…