DEWALT DCS16125 4 Inch Gauge Finish: Efficient and Precise Woodworking Solution Review

This product is not DeWalt. These nails are not galvanized. To my knowledge, DeWalt had a yellow background with black lettering. There is no contact information to contact this seller. FRAUD! I was waiting for these nails because I needed them for a mahogany fence I was building. When they arrived the box didn't say "galvanized" like the item they show. FRAUD !

Arrived quickly in perfect condition. They are marked for use in the box but that doesn't matter as all my projects are mostly indoors so galvanizing isn't important. I have 15, 16 and 18 gauge nailers and lots of nails for each. I don't think many of them are electroplated, if at all. If this was an outside project I would use galvanized screws and waterproof glue.

The reason for the 3 stars is that the box arrived broken, even some sets of nails were broken too. To be honest I didn't try to settle for them. I didn't want to go through the fear. The reason was obvious. It was packaged in a different box with padding/seal on only 3 of the 6 sides. Incredibly stupid, and many sellers do this. They have obviously chosen to prioritize lower processing costs over their customers' convenience and satisfaction. Short-term thinking and 3 stars are a gift IMHO.

I received the "Box Pack". These are NOT galvanized nails. If they "were" electroplated it would NOT say "for internal use only". Product number but the word DEWALT is printed in YELLOW letters on a black box and NON-BLACK letters on a yellow box. The manufacturer claims not to use such packaging. So my only guess at this point is to assume it is a counterfeit product and I will be sending it back to Revain. NOBODY ON THE PACKAGING I RECEIVED SAYS THAT THESE NAILS ARE GALVANIZED.

I have used 3/8 saw board (rather than drywall) for interior walls and ceilings around the home. I use these nails with a Dewalt 18V nail gun to nail the panels. The pins hold the panels well and aren't long enough to catch the wires in the studs. As expected they sometimes ruin the surface of the plate when you hit it on the nail plate. It is best not to insert any of these pins into the panel until you are sure the panel is in the correct place. When hanging the panels I held the panel where…